自考题库
首页
所有科目
自考历年真题
考试分类
关于本站
游客
账号设置
退出登录
注册
登录
出自:海船船员证
顶风顺流情况下航行,船舶对水航速V
L
,对地航速V
G
,船速V
E
,航时t,则()。
A:V
G
<V
L
<V
E
B:V
L
>V
E
,且V
L
>V
G
C:V
G
>V
L
>V
E
D:V
L
<V
E
,且V
G
>V
L
海面蒸发量的大小主要取决于()
A:海面上空气的饱和差和海面上风速的大小
B:表层海温的高低
C:C.B都对
D:D.B都错
The injured stevedore paid()attention to the loading instructions from the chief officer.
A:small
B:little
C:few
D:a few
铝质和玻璃钢舱口盖特点是() ①重量轻; ②耐腐蚀; ③制造简单造价低; ④目前中小船常用。
A:①③
B:②④
C:①④
D:①②
(),如辽阔的海洋、无垠的沙漠、冰雪覆盖的大陆和极区等都可成为气团形成的源地。
A:大范围物理性质不均匀的下垫面
B:低层存在逆温
C:对流层风的垂直切变要小
D:具备大范围性质比较均匀的下垫面
Moisture in a refrigeration system can cause ().
A:freezing the expansion valve closed
B:corrosion of system piping
C:improper temperature regulation
D:all of the above
液体和固体相接触时,若能产生液体润湿固体的现象,这说明()。
A:附着力大于内聚力
B:附着力小于内聚力
C:两者相等
D:不能确定
装运不散发水分的干货,从寒冷地区驶往温暖地区时一般应进行()通风。
A:循环
B:自然排气
C:机械
D:断绝
下列哪种船舶应避免在航道内锚泊().
A:任何船舶
B:帆船
C:从事捕鱼船
D:机动船
下列有关锚的描述正确的是:()
A:各类型锚应在一定重量下具有尽可能大的抓力
B:有杆锚锚爪能顺利抓入土中且抓力大,船上都使用
C:特种锚是特种船使用的,如大型船舶等
D:山字锚收藏和抛起方便且不易走锚,故普遍使用
锅炉运行中,遇到哪些情况要应急停炉?
The major cause of fuel pump and injection system problems is ()
A:improper adjustments
B:contaminated fuel
C:kinked fuel lines
D:excessive engine vibration
L≥50m船舶的舷灯最小能见距离为:().
A:5海里
B:3海里
C:2海里
D:1海里
如果申请审核的公司是船舶管理公司,应满足哪些条件?
舱壁的作用有() ①分隔舱容; ②阻止火灾蔓延; ③减少自由液面的影响; ④提高船舶的抗沉性能。
A:①、③、④;
B:②、③、④;
C:①、②、③、④;
D:①、②、③。
Attention is ()the advice on the use of charts in The Mariner’s Handbook Chapter 3,Section 1.
A:fixed to
B:needed for
C:pushed to
D:drawn to
新造船舶交接签字完毕后,轮机长除组织安全检查外,还应该做好()工作。
A:确定图纸及各种技术资料的存放地点
B:机舱各种备件、工具的定位
C:检查存油种类、数量,及时申报油料
D:确定轮机物料申请项目及数量
为了防止锅炉点火时燃气爆炸,注意事项中不合适的是()。
A:点火前要有足够的预扫风时间
B:点火时应开足风门
C:熄火后风机应延后停
D:停火期间应防止喷油器滴漏
如果在提单的收货人栏内只填写“凭指示”字样,这样的提单称之为()。
A:托运人指示提单
B:记名指示人提单
C:选择指示人提单
D:任意指示人提单
73/78防污公约规定,油船排放货油舱油性混合物时,距最近陆地应为()。
A:12海里以上
B:25海里以上
C:50海里以上
D:100海里以上
在主机遥控系统中,若主机运行时测速装置失灵,将出现()。
A:主机自行停车
B:主机保持原设定转速或自动降至最低稳定转速
C:主机转速自动降至发火转速
D:A或B
根据《海上交通安全法》,船舶在下列哪些情况下必须遵守主管机关的特别规定() Ⅰ.通过航行条件受限制的区域; Ⅱ.进出港口和通过交通管制区; Ⅲ.通过交通密集区; Ⅳ.通过禁航区时。
A:Ⅰ~Ⅳ
B:Ⅰ~Ⅲ
C:Ⅰ、Ⅲ、Ⅳ
D:Ⅱ~Ⅳ
圆轴扭转变形时,剪应变和剪应力的分布规律是()。
A:轴心处剪应变为零,而剪应力最大
B:轴表面处剪应变最大,而剪应力最小
C:轴心处剪应变最大,剪应力也最大
D:轴表面处剪应变最大,剪应力也最大
为什么要进行舱口盖的水密测试?舱口盖的水密测试有几种方式?简述超声水密测试的基本原理及过程。泄
How can the chance of contaminating hydraulic fluid be decreased when working on hydraulic system?()
A:clean the fittings before they are disconnected
B:Place drip pans under leaky fittings
C:Seal any cracks in lines with Permatex
D:Coat all threads with graphite oil
When taking a Pilot from a pilot vessel in a seaway,which way should you head your vessel if the ladder is on the leeward side().
A:Bow to the sea and no way on your vessel
B:Sea on the lee quarter with ship moving ahead slowly
C:Sea on the weather bow and ship moving ahead slowly
D:Sea on the quarter with sternway on the ship
据对使用高硫分燃油直流换气的缸套磨损研究,其最大磨损量多发生在上止点附近的原因是()。
A:上止点附近发生熔善磨损
B:上止点附近发生磨料磨损
C:上止点附近颗粒磨损
D:上止点附近发生腐蚀磨损
Stability is determined principally by the location of the point of application of two forces: the downward-acting gravity force and the().
A:upward-acting weight force
B:downward-acting weight force
C:upward-acting buoyant force
D:environmental force
按船舶发电柴油机的工作特点,其使用的喷油泵供油量调节方式是()。
A:始点调节式
B:终点调节式
C:始终点调节式
D:任意一种
板架结构
首页
<上一页
1541
1542
1543
1544
1545
下一页>
尾页